SAVE 5%The SPD 200 cellar sump pump system is designed specifically for dewatering cellars. Can be used with perimeter channel or simply drilled to allow in ground water.
This is a single "plug and play" pump kit for quick and easy installation. System can also take grey water including showers, sinks, washing machines etc.
Manufactured in high quality MDPE. System has the added benefit of having 2 x 9500lph pumps. Used as both a back-up pump and ability to pump twice the speed as the single pump system.
The unit has in integral audible alarm and is designed to be located outside the sump pump in a dry location.
In the event of a power failure the battery back-up unit will run the pump at normal capacity with no loss of performance.
The unit has been tested independently by us at SPD and will run continuous for 20 minutes. This equtes to approx 4 hours running with the cycles of the pump (eg pump runs for 55 seconds 4 times per hour) or approx 130ltr per minute
(battery fully charged after 3 hours)
UPS Dimensions; 247mm x 120mm x 443mm
Features;
Energy share socket
Ability to switch on the UPS in the absence of mains power (cold start)
Batteries are user replaceable without switching off quipment and without interruption to the load
Full configurable using UPS tools configuration software
High reliable batteries (automatic and manually-activated battery test)
Built in short circuit protection
Auto restart (when mains power is restored, after discharge of batteries)
GS/Nemko Safety seal
SPD200 Sump Pump includes: |
---|
1 x Chamber - 530mm dia x 585mm deep (100ltr storage) with anti-floatation |
1 x UPS battery back up system |
1 x Sealed pedestrian rated lid |
2 x Ama 301 sump pump (9,000lph max each) 6m lift |
1 x Internal 1¼" PVC (class C) discharge pipe work Kit |
2 x Quiet non return valve |
1 x 40mm cable duct |
1 x 12 Months warranty |
Can be used inside or outside
For the removal of all clean and dirty water (except for toilet waste)
Total lift 6.5m
230v
0.40kw
Typical duty 2.2lps / 3m head